Panasonic Panafax UF-895, Руководство по обслуживанию

Страница: 157 / 342

Service Modes
157
Note 1: No. 070 LINE ERROR-Transmit condition of RTP/PIP or RTN/PIN
Note 2: No. 071 TOTAL ERROR-Transmit condition of RTP/PIP or RTN/PIN
Note 3:
The default setting of parameters depends on the country’s specifications or regulations. Print the Function Parameter List to
confirm the default settings.
Note 4:
This parameter will be available as a running change in the future.
075 MH/MR/MMR/JBIG 1 = MH (MH only)
2 = MR (MH or MR)
3 = MMR (MH or MR or MMR)
4 = JBIG Selects the coding scheme.
076 Not used
077 RX JAM LENGTH 1 = Off (unlimited)
2 = 2 m
3 = 8 m Selects the maximum length of a received
document that can be printed.
078
079 Not used
080 DOC TOP FEED -5.0 mm
~
+5.0 mm Adjusts the distance between the scanning sensor
ON position and the scanning start position.
081 DOC END FEED -5.0 mm
~
+5.0 mm Adjusts the distance between the scanning sensor
OFF position and the scanning end position.
082 JAM LENGTH 1 = 1 m
2 = 2 m
3 = 8 m
4 = Unlimited Selects the maximum length of the document that
can be scanned.
083 Not used
084 LINE AS NO PAPER 1 = Ring (ring)
2 = Busy (keep line busy) Selects whether to ring or send a busy tone to the
remote station when the recording paper runs out
or the unit cannot receive because of any trouble.
085 Not used
086 REDUCTION FINE 1 = Off
2 = On Selects whether the resolution is preset to Fine,
when sending with reduction B4
→
A4.
087 DARKER LEVEL 0 = Lightest Contrast
~
15 = Darkest Contrast Selects the contrast level.
0
← →
15
Lightest
← →
Darkest
088 NORMAL LEVEL
089 LIGHTER LEVEL
090 CONTINUE FROM ADF
(See Note 4) 1 = Off
2 = On (Default) Selects whether the machine will continue the
transmission and send the remaining document(s)
from the ADF when the memory reaches 100%
(Memory Overflow) while storing the documents.
091 Not used
092 SMOOTHING 1 = Off
2 = On Selects whether the smoothing function is
available.
093
~
099
Not used
Signal
Setting
1:128 2:256 3:512 4:1024 5:2048 6:Off
MCF/PIP 0-31 0-63 0-127 0-255 0-511 Always
RTP/PIP 32-63 64-127 128-255 256-511 512-1023 -
RTN/PIN 64-127 128-255 256-511 512-1023 1024-2047 -
Signal
Setting
1:5% 2:10% 3:15% 4:20%
MCF/PIP 0-2 0-4 0-7 0-9
RTP/PIP 3-4 5-9 8-14 10-19
RTN/PIN 5- 10- 15- 20-
Function Parameter Table
No. Parameter (see Note 3) Selections Function