CONCEPT
SYSTEM
EXAMPLES
CONNECTIONS
PR
ODUCTS
BLOCK
D
IA
GRAMS
41
3
CONNECTIONS
WR-201E
CONCEPT
SYSTEM
EXAMPLES
CONNECTIONS
PR
ODUCTS
BLOCK
D
IA
GRAMS
40
3
CONNECTIONS
WR-201E
CONNECTIONS
PA System Name
Number of Possible Connections
Name
Type
Remote Microphone (WR-201E)
Mixing Power Amplifier
WA-MA120N
2
WA-MA240N
2
Connectable PA Systems
Refer to the following table to determine the number of Remote Microphones that can be connected to the PA systems.
Cable Diameters
Binding Cables
Bind the cables as shown in the figure below.
The insulation at the end of a cable being
connected should be stripped to 11 mm
(standard strip length).
•
11 mm
Cable Lengths
200 m or less
500 m or less
Shielded cable
0.5 mm
2
(AWG20) to 1.25 mm
2
(AWG16)
Control cable
ø
0.8 mm (AWG20) to
ø
1.2 mm (AWG16)
ø
1.2 mm (AWG16)
PA System Name
Cable Type
Mixing Power Amplifier
Shielded pair cable
• Use cables that have a line resistance of 7
Ω
or less if one
of the cables listed above is not available.
• Use a multicore cable if you intend to move the Remote
Microphone freely around on the table while using it.
Use an adequate shielded cable (either a one wire or two-wire type according to the
PA system being used) for connecting to the LINE OUT terminal.
Mixing Power Amplifier (WA-MA120N/240N) Connection-1
Select -22 dBV (RM) with the switch 1 on the back of the Mixing Power Amplifier.
Volume should be adjusted to the desired level using the Volume control [RM] knob
2
on the back of Mixing Power Amplifier
(WA-MA120N/240N).
Making connections for all-zone announcements
Note 1
Note 1:
Connect to play the Mixing Power Amplifier's call sign from the CALL SIGN button on the Remote Microphone.
Note 2:
When using more than one Mixing Power Amplifiers, refer to the instructions on Connection between Mixing Power
Amplifiers. (See page 43.)
Important:
• Set the call sign volume-control on the bottom of the Remote Microphone to its lowest setting to use the Mixing Power Amplifier's
built-in call sign.
WA-MA120N
or
WA-MA240N
WR-201E
