Before using
11
LSQT1130
ª
How to turn the power on and off with
the LCD monitor/viewfinder
When the power switch is set to [ON], the power
can be turned on and off with the LCD monitor
and the viewfinder when the unit is in Tape
Recording Mode.
1
Open the LCD monitor out or extend the
viewfinder to use.
(
-12-
)
≥
The LCD monitor or the viewfinder will be
activated.
2
Close the LCD monitor and retract the
viewfinder.
≥
The power will not turn off unless the LCD
monitor is closed and the viewfinder is
retracted.
≥
The status indicator automatically goes off
and the power turns off. (If quick start is set to
[ON] (
-13-
), the unit goes into quick start
standby mode and the status indicator lights
green.)
≥
The power does not turn off even if the
LCD monitor is closed and the viewfinder
is retracted while recording on a tape.
3
Open the LCD monitor or extend the
viewfinder to turn the power on and use the
movie camera again.
≥
The status indicator lights red and the power
turns on.
Setting date and time
When the movie camera is turned on for the first
time, [SET DATE AND TIME] will appear.
≥
Select [YES] and press the centre of the
joystick. Do steps 2 and 3 below to set the date/
time.
If the screen shows the incorrect date/time, then
adjust it.
≥
Set to Tape Recording Mode.
1
Set [BASIC] >> [CLOCK SET] >> [YES]. (
-17-
)
2
Move the joystick left or right in order to
select the item to be set. Then move the
joystick up or down to set the desired value.
≥
The year will change as follows:
2000, 2001, ..., 2089, 2000, ...
≥
The 24-hour clock is used.
3
Press the joystick to determine the setting.
≥
The clock function starts at [00] seconds.
ª
About date/time
≥
The date and time function are driven by a
built-in lithium battery.
≥
Make sure to check the time before recording
because the built-in clock is not very accurate.
ª
Recharging the built-in lithium battery
≥
If [
0
] or [--] appears when the camera is
turning on, then the built-in lithium battery has
run down. Use the steps below to charge the
battery. When turn on the power for the first time
after charging, [SET DATE AND TIME] will
appear. Select [YES] and set the date and time.
Connect the AC adaptor to the camera or attach
the battery to the camera, and the built-in lithium
battery will be recharged. Leave the camera as
is for approx. 24 hours, and the battery will drive
the date and time for approx. 6 months. (Even if
the [OFF/ON] switch is set to [OFF], the battery
is still being recharged.)
OFF
ON
OFF
ON
OFF
ON
LSQT1130_ENG.book 11 ページ ２００６年１２月１６日 土曜日 午後８時４５分
