Before Use
-8-
Setup on the Movie Camera:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Controller Mode. (
-13-
)
Setup on the Remote Controller:
[VCR1]:
Press the [
D
] Button and [
∫
] Button
simultaneously.
1
[VCR2]:
Press the [
E
] Button and [
∫
] Button
simultaneously.
2
≥
When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.
Power Supply
ª
Using the AC Adaptor
1
Connect the DC Input Lead to the Movie
Camera.
2
Connect the DC Input Lead to the AC
Adaptor.
3
Connect the AC Mains Lead to the AC
Adaptor and the AC mains socket.
≥
The AC Mains Lead’s outlet plug does not fit
entirely into the AC Adaptor socket. A gap will
remain as shown
1
.
≥
Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Movie Camera to [OFF] and make sure
that Power Lamp is not lit.
ª
Using the Battery
Before use, fully charge the Battery.
≥
We recommend using Panasonic’s Battery.
≥
We cannot guarantee the quality of this Movie
Camera when batteries of other companies are
used.
INDEX
INDEX
SELECT
STOP
K
L
∫
STILL ADV
T
W
PAUSE STILL ADV
6
1
5
;
E
D
P.B. ZOOM
2
1
1
1
Attach the Battery to the AC Adaptor and
charge it.
≥
Since the Battery will not be charged when
the DC Input Lead is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥
The [CHARGE] Lamp lights up, and charging
starts.
≥
When the [CHARGE] Lamp goes off,
charging is completed.
≥
When charging the overdischarged battery,
the [CHARGE] lamp blinks at first, but the
battery is charged normally. When the
temperature of the battery is too high or low,
the [CHARGE] lamp blinks and the charging
time becomes longer than usual.
2
Attach the charged Battery to the Movie
Camera.
Disconnecting the Power Source
Set the [OFF/ON] Switch
(42)
to [OFF] and, while
pressing the [PUSH BATT] Button
(47)
, slide the
Battery or DC Input Lead upward to disconnect it.
≥
For other notes concerning this item, see
-36-
.
PUSH
BATT
ON
OFF
(47)
(42)
33EGE-ENG.book 8 ページ ２００４年２月９日 月曜日 午前９時５５分
