25
English
Appendix
In these cases?
The power failed.
●
Keep the doors closed and do not store additional food.
●
[FRESH FREEZING] and [QUICK ICE MAKING] stop. Set these functions
again to use after power recovery.
The power plug was
disconnected.
●
Wait at least 7 minutes, and then plug in the power plug.
(If it is plugged in immediately, the compressor will be overloaded, which may
cause a malfunction.)
The refrigerator is not
used for a long time.
●
Remove all foods and drinks and clean the refrigerator.
Disconnect the power plug.
Clean the compartments and the ice-making tray. (P. 17 ~ P. 19)
Keep the doors opened for 2 to 3 days to dry the compartments.
(When drying is insufficient, the compartment may get moldy or have a foul
smell.)
The room lamp does not
turn on.
→ Consult your dealer. (When the room lamps are flashing, see P. 26.)
Glass was broken.
(Glass trays
•
doors)
●
When glass trays and glass doors were broken, do not touch the broken glass.
→ Contact your dealer immediately.
Moving the refrigerator.
●
To prevent the floor surface from being damaged, place a protective board or
the like.
Disconnect the power plug.
Remove the leg cover, and then raise the adjustable legs. (P. 6)
Move the refrigerator in the forward or backward direction.
After moving, fix the refrigerator completely with adjustable legs. Reattach the
leg cover. (P.6)
When you move or
transport the refrigerator.
●
Transport the refrigerator with at least 2 people. Do not transport it in a
horizontal position. (It may cause an injury or break down of the refrigerator.)
Remove the food and drinks and discard water in the water supply tank.
Stop the auto ice making function. (P. 15)
Clean the ice-making tray. (P. 19)
Disconnect the power plug.
Remove the leg cover screw in the adjustable
legs. (P. 6) (Remove the leg cover before
transporting the refrigerator.)
Place a vessel underneath the drainage hole
(whose height is 2 cm or less).
Tilt the refrigerator backward to drain water from the
drainage hole. (To prevent water from leaking out,
tilt back the refrigerator slowly.)
Place a protective sheet or the like and move the
refrigerator. (Since water may remain the inside.)
Attention
●
If frost remains on the cooling unit (not visible from the outside) in the
refrigerator, water may spill when it is moved.
(It takes approximately 15 hours for the frost on the cooling unit to melt after
the refrigerator power plug is disconnected.)
Drainage
hole (bottom
of the back)
Place container and rag.
(Water may overflow.)