Panasonic NR-F532TT, Руководство по обслуживанию

Страница: 31 / 61

31
8. Unscrew screw which fixes inject pipe cover. (1 piece)
(The screw is fixed on the ceiling of ice compartment.)
9. Insert screw driver (-) into triangle mark portion of inject
pipe cover and unhook inject pipe cover (4 portions.)
10. Disconnect connector of inject pipe A'ssy. (1 piece)
11. Lift up inject tube A'ssy and remove it.
CAUTIONS
• Set inject tube A'ssy in place firmly.
Otherwise, water leakage may happen.
• Connect connector firmly.
• Arrange electric wires so that these are not loosen.
12.1.3.
SENSOR PCC
1. Remove water supply corner and PC duct plate.
(Refer to "DISASSEMBLY OF PC COMPARTMENT" (1-
6).)
2. Remove screws for sensor cover and pull toward you.
3. Remove sensor PCC from sensor cover.
ASSEMBLY REPLACING sensor PCC
1. Cut the wire of sensor PCC.
2. Connect new sensor PCC to wire from cabinet.
(The Scotch lock is used for the connection.)
3. The Scoch lock is stored inside of sensor cover FC, and
fixed the sensor cover by screw.
12.1.4. TWIN DAMPER THERMOSTAT
1. Remove PC duct plate
(Refer to "12.1.DISASSEMBLY OF PC")
2. Unscrew the screw of Damper cover (Harness cover),
then remove Damper cover.
3. Disconnect the connector of the Damper
(Measure resistance of the Damper when it is needed.)
4. Remove INS duct cover TOP
CAUTIONS
INS duct cover is going to be broken easily, therefore
new INS duct cover is sent with the Damper when it is
ordered.
a. Cut the Seal tape (yellow) by a cutter along joint part
on INS duct cover TOP side.
b. Same as above, cut Foam tape (white) on front side.
c. Pull the wire harness to the right and remove INS duct
cover TOP.