Troubleshooting
Check to be sure that the temperature control lever is at the proper position. (P.7)
Check to ensure that the refrigerator is not overloaded with foodstuffs or that
hot food have been placed in the refrigerator.
Is the refrigerator exposed to direct sunlight or a heat source? (P.4)
Is the refrigerator door completely closed?
Is the refrigerator door opened frequently?
Check that the plug and wall socket are in good condition.
Check if there is any problem with the mains fuse or house wiring.
Check by unplugging for 10 minutes and plugging back in.
Check if the refrigerator is located on a stable, level oor and is installed correctly.
Use the adjustable bolt if required to level the refrigerator. (P.5)
Check if there is any object in contact with the refrigerator.
Cracking sound within caused by the parts adjusting temperature which is normal.
After installation, the refrigerator may make loud noise.
The noise will be less when the refrigerator has been cooled.
Was the food placed near the cold air duct?
If the temperature control has been set to “Max” try adjusting the temperature
control to the “Min” setting.
Has the food been placed in the chilled case?
Condensation may appear on the surface of the cabinet when humidity is high
or air circulation around the unit is poor.
If there is condensation inside, check if the door is completely closed.
Is the refrigerator frequently opened or left open for a long time?
Have any hot foodstuffs been placed inside the refrigerator?
Has the “Quick Freezing” mode been activated? (P.8)
Is the temperature setting of the freezer compartment set to
something other than “Med”?
Has the door been opened frequently or has hot food been placed in
the refrigerator?
The learning function may automatically disable ECONAVI operation
during times of frequent use.
Is there a power failure?
If a power failure occurs, the learning function data collected up until
the point of power failure will be lost. The ECONAVI operation will
rarely be performed until the learning function has collected data
again.
If the auto defrost function is turned on during ECONAVI operation,
the normal cooling operation will need to be performed after defrost.
Therefore the ECONAVI operation may be stopped
during this defrost/cooling process.
The learning function may sometimes restart the
normal cooling operation.
Is the light intensity sensor hidden?
Are there dirt or scratches on the control panel
where the light intensity sensor is located?
ECONAVI operation may be performed while
the refrigerator is being used depending on the
conditions of use, but the cooling performance is
maintained.
The refrigerator
does not cool
enough.
The refrigerator
does not operate.
Check here.
In these cases?
The refrigerator
generates noise.
Food becomes
frozen
Vapor generated
inside and outside
the cabinet /
surface of door.
ECONAVI does not
operate.
(the ECONAVI lamp
does not light)
ECONAVI operation
is rarely performed.
ECONAVI operation
is stopped part way
though.
ECONAVI operation
is performed too
often (the ECONAVI
lamp rarely turns off).
The ECONA
VI lamp does not light properly
.
15
NR-BY608X(EN)(RBD).indd 15
NR-BY608X(EN)(RBD).indd 15
6/10/2559 BE 10:21 AM
6/10/2559 BE 10:21 AM
