Operation
10
Installation
Preparations
Maintenance
Remove all the packing materials and tapes.
Wipe the inside of the refrigerator using a soft cloth which has been dipped in lukewarm water and then
wrung out.
Wash and completely dry the ice box before installing it. (Do not use a dish dryer, hair dryer or other
appliance when drying.)
Connecting the power plug to the power outlet
When the power plug is connected to the power outlet, the temperature display starts
flashing as shown in the figure on the right, and cooling starts inside the refrigerator.
The temperatures displayed at this time are not the actual temperatures.
When the temperature of the fridge reaches 8 °C, the freezer reaches -12 °C and the
Vitamin-Safe Zone reaches 5 °C, the temperature display stops flashing and lights, and it
shows the actual temperature.
It takes about half a day to reach the set temperatures (when the room temperature is
around 32 °C, there is no food inside the refrigerator, and the doors are closed).
Place the food inside the refrigerator only after it was confirmed that the refrigerator
compartment had been cooled.
Notes:
●
Cooling may take longer in the summer months or at other times when the room
temperature is higher.
● While the temperature display is flashing, the alarm sounds to warn that the
temperature has risen. The alarm can be turned off by pressing
.
●
If you need to unplug the refrigerator, wait at least 10 minutes before you plug it back
in again. You might damage the compressor.