Panasonic NR-B30FG1, Руководство по обслуживанию

Страница: 46 / 67

46
11.8.4. Install Door A'ssy FC
1. Install Hinge Bottom L
a. Tear off the Label Bottom that is sealed at the
position of Hinge Bottom L of bottom and left side
of the appliance.
b. Seal the Label Bottom at the setting position of
Hinge Bottom R of bottom and right side of the
appliance.
c. Pull out the Cap Hinge that is inserted in the set-
ting hole of Hinge Center L of middle height and
left side of the appliance.
d. Insert the Cap Hinge in the setting hole of the
Hinge Center R of middle height and right side of
the appliance.
NOTES
• Wipe a grease of around the area with a new or
cleaned cloth before installing Label Bottom and
the Cap Hinge, because grease might remain.
• Wipe a grease of around gasket touching face of
body and the gasket with a new or cleaned cloth.
e. Install Hinge Bottom L by bundled screws that are
fixation it.
(Torque of screw : 6 ± 2 N
・
m)
CAUTION
• These screws of Hinge Bottom L are needed to
screw to use a torque wrench.
2. Install Door A'ssy FC
a. Install Shim Hinge FCT that was removed before
(see 11.8.2.1)- in the hole of upper and left side of
Door A’ssy FC.
b. Install Cap Hinge Pin FCT in upper and right side
of Door A’ssy FC.
c. (3)First open Door A’ssy FC, install Hinge Center L
in the Refrigerator by bundled screws for fixation.
(Torque of screw: 6 ± 2 N
・
m)
d. Apply the grease of bundled parts on around pin
of Hinge Bottom L, and insert Door A’ssy FC into
Hinge Bottom L.
e. Apply the grease of bundled parts on around of
Shim Hinge FCT on Door A’ssy FC.
f. Shim Hinge FCT and Hinge Center L put together,
and screw Pin Hinge Center on Hinge Center L.
(Torque of screw: 6 ± 2 N
・
m)
CAUTION
• Pin Hinge Center is screwed on Hinge Center L to
use a torque wrench.
• Two screws of Hinge Center L are screwed to use a
torque wrench.
CAUTION
• Screw these screws up Hinge Center L and hinge
Bottom L securely, there must not be them loosen-
ing. And screw Pin Hinge Center L up Hinge Center L
securely too, there must not be it loosening.
Because it might become cause of an accident of
falling door and there is a possibility that an unex-
pected serious accident occurs.