34
Electrical Requirements
Look at the Name Plate to know the rating voltage and connect the Dishwasher to the
appropriate power supply. Provide a separate circuit serving only for this Dishwasher.
Electrical Connection
Ensure the voltage and frequency of the power correspond to those on the Name Plate.
Only insert the Power Plug into an electrical socket which is earthed properly. If the
electrical socket to which the Dishwasher must be connected is not appropriate for the
Power Plug, replace the socket, rather than using adapters or the like as they could cause
overheating and fi re.
Water Connection
Inlet Hose Connection
Connect the Inlet Hose to a threaded 3/4 (inch) connector and
make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure that the
water is clean. This precaution is needed to avoid the risk of the
water inlet becoming blocked and damage the Dishwasher.
Please fasten the nut lightly by hand and tighten it. The proper
tightening torque is 5-10 N.m (50-100 kgf.cm).
■
Note:
• The maximum inlet water pressure is 1 MPa.
• The minimum inlet water pressure is 0.04 MPa.
CAUTION
The appliance is to be connected to the water mains by new detachable hose-
sets supplied with the appliance. Old hose-sets should not be used.
Close the water tap after using.
Installation Instructions
