Panasonic NN-CS597S APH, Руководство по обслуживанию

Страница: 17 / 42

6.7. Stirrer motor
1. Remove the motor cover by breaking off at the 8 spots
indicated by arrows with a cutter or the like.
NOTE:
After removing the motor cover, be sure that cut
portions are properly trimmed or bent to the Inside
so that no sharp edges will be exposed to outside.
2. Disconnect 2 lead wires from stirrer motor terminals.
3. Remove 2 screws holding stirrer motor.
NOTE:
After reinstalling the new stirrer motor and
reconnecting the 2 lead wires, reinstall the motor
cover by rotating it around 180, tucking the 2 tabs
under the base in the 2 provided slots, then screw
the single tab to the base using a screw.
6.8. Pump motor
1. Remove water tank from escutcheon base.
2. Keep pressing [Microwave with Steam] pad for more than 2
seconds to drain the water remaining in the water pipes and
tubes into oven cavity.
3. Pull out tube A connecting to pump motor from copper pipe.
4. Disconnect all wiring connectors from D.P.C board HU
(relay board).
5. Remove 1 grounding screw holding on cavity front plate.
6. Open the door of oven, slide the escutcheon base upward
and out slightly.
7. Pull out tube B from inlet of pump motor.
8. Remove 2 screws holding pump motor bracket on
escutcheon base.
9. Slide out pump bracket from bottom rail of escutcheon
base.
10. Slightly uplift the pump motor over the locking tabs on the
pump motor bracket, then slide the pump motor out.
17
NN-CS597S