Panasonic NCJD40C, Руководство по эксплуатации

Страница: 18 / 36

18
Dispense hot water
Press to unlock the flow control pad.
Locking will be done automatically about 10 seconds after
the end of dispensing.
Place the vessel at the dispensing position and dispense hot water.
The unlock lamp goes out and no hot water will be dispensed
even when the button is pressed.
The dispensing quantity can be adjusted by the force
with which the button is pressed.
¥ Strong: Strong flow
¥ Weak: Weak flow
¥ For some time after boiling, bubbles from the boiling may
get into the pump and dispensing may be impaired.
This can be corrected by opening and closing the lid.
* Watch out for the steam when opening the lid.
Note:
Unlock lamp lit
Lock
Unlock
¥ To lock the button immediately after dispensing water.
Press the . The unlock lamp will go out.
Lock
Unlock
Press to dispense hot water.
Flow
Control
Flow
Control
1.0
2.0
Beep
Refill before the "Refill" position is reached.
Caution:
"Refill" position
¥ Do not leave the jar pot standing with an open lid.
(This may cause the function for prevention of empty
heating to operate.)
Caution:
¥ Do not discharge hot water from the operation side.
(This can cause trouble.)
¥ Do not leave water in the inner container. (This can cause
rust and/or smell.)
Note:
¥ When there is still a remaining charge after the plug has
been pulled, the temperature indication will appear.
Refill when the water level has dropped.
Disconnect the plug and remove the lid.
Discharge from the discharge position.
Empty the jar pot when it is not being used.