FURTHER INFORMATION
Notice
About gas sensor
•
PM2.5 sensor
PM2.5 sensor
The sensor detects air pollutants and shows the pollution level by the PM2.5 concentrations. In auto
operation, the product can optimize the air volume for purifying the air according to the detected
pollutants.
Sensing scope
May detect
Sensor
Odor from cigarettes, incense, cooking, pets
Cosmetics, alcohol, sprays, etc.
Humidity (water vapor), oil
The wind generated when a door
is opened or closed, or sudden
temperature changes
PM2.5 (0.3 µm~2.5 µm particles)
Indoor dust (dust, dead bodies and excreta
of ticks, mold spores, pollens, etc.)
Smog (cigarettes, incenses, etc.)
Oil, fog-stated water drip
The sensor’s operation may vary depending on the indoor airflow condition if a heater is placed
near the product in a room.
The sensor is not designed to detect bacteria and viruses.
About nanoe
TM
X
About brightness reaction
Room temperature: about 5
℃
～
35
℃
(dew-point temperature: 2
℃ or above
)
Conditions for nanoe
TM
X
generation
Relative humidity: about 30%
～
85%
The product detects the indoor brightness by the light sensor and adjusts the brightness of the LCD
accordingly. When the indoor ambient light gets dark, the LCD dims accordingly.
nanoe
TM
X is generated by using the air in the room. Therefore, due to the differences in
temperature and humidity nanoe
TM
X may not be generated stably.
When nanoe
TM
X is generated, small amount of ozone will be released. However, the quantity will
be far less than the level in natural environment such as forest, and not be harmful to human beings.
Such problems may occur because
of the difference in sensitivity of
PM2.5 sensor.
FAQ
Please confirm the following before you put questions forward or send the product for repair.
There is a slight sound when nanoe
TM
X
is being generated. Depends on the
environment and operation mode, the
sound may be a bit loud or inaudible
but it is not abnormal.
Why is a “jee” sound from
the emission outlet?
Why has the gas pollution
level display never changed?
Why does the PM2.5 figure
remain unchanged?
Such problems may occur because
of the difference in sensitivity of
PM2.5 sensor.
The adsorption capacity of filter
reaches saturation, odor will also be
blown out again with the wind
because of excess adsorption.
The filter has not been cleaned after
getting dirty.
Why will air outlet blow out
the odor?
14
Gas sensor
The gas sensor and PM2.5 sensor do not operate when the operation is set to “Off”.
