Panasonic NA-147VB6WGB, Руководство по обслуживанию

Страница: 14 / 33

14
FAILURE PROBABLE CAUSE METHODS OF ELIMINATION
Excessive foam in
the detergent
drawer
Too much detergent has been
used.
Press the start/pause button. In order to stop
the foam, dilute one table-spoon of softener in
half liter of water and pour it in the detergent
drawer. Press the start/pause button after 5-10
minutes. Arrange the amount of the detergent
properly in the next washing process.
Wrong detergent has been used.
Use only the detergents produced for full
automatic machines.
The washing result
is bad.
Laundry too dirty for the program
you have selected.
Select a suitable program.
The amount of detergent used is
not sufficient. Use more detergent according to the
detergent.
The washing result
is not good.
Clothes exceeding the maximum
capacity has been filled in machine. Put the clothes in machine in a manner not to
exceed its maximum capacity.
Water may be hard.
Use the amount of detergent according to the
declaration of the detergent producer.
Distribution of the clothes in
machine is not well-balanced. Spread the clothes inside the machine in an
orderly and well-balanced manner.
The water is seen
in the drum during
washing.
No failure. The water is at the lower
part of the drum.
There are residues
of detergent on the
clothes. The pieces of some detergents
which do not dissolve in water may
stick to clothes as white stains. By calibrating machine for “Rinsing” program,
make an additional rinsing or eliminate the
stains After drying with the help of a brush.
There are grey
stains on the
clothes.
These stains may be caused by oil,
cream or ointment.
In the next washing operation, use the
maximum detergent amount declared by the
detergent producer.
The spinning
process is not done
or starts with delay.
No failure. The unbalanced load
control works in that way.
The unbalanced load control system will try to
distribute clothes in a homogenous manner.
After clothes are distributed, passage to
spinning process will be realized. In the next
washing process, place clothes into the
machine in a well-balanced manner.
9. Critical Torque Values
Assembly Locat ı on Bolt/Nut
Torque Min.
(Nm)
Torque Nom.
(Nm)
Torque Max.
(Nm)
Air Pressure
Wrench (rpm)
*
Transport Screw Assembly Transport Screws 6.50 6.50 7.00 1000
*
Motor Assembly Motor Screws 6.00 6.50 7.50 800
*
Front Concrete Weight - Front Tub
Assembly
Front Counterweight Screws 14.00 14.50 14.75 600
*
Upper Counter Weight Assembly Upper Counter Weight Screws 25.00 27.50 30.00 440
*
Pulley – Drive Shaft – Washing Group
Assembly Pulley – Drive Shaft Assembly
Bolt
39.50 40.00 40.50 440
*
Heater Assembly Heater Assembly Nut 3.85 4.00 4.00 970
The bolts/nuts above are important for product safety purposes. Please tighten screw, bolts and nuts according to the torque values given in
table above.