GB12
GB13
English
●
②
●
①
Frozen
attachment
(
)
"MJHOUIFi
U
” mark on the motor housing and
UIFi
V
” on the juicing bowl.
"MJHOUIFi
U
” mark on the motor housing and
UIFi
T
” mark on the juice attachment.
1
Insert the squeezing screw into the centre.
2
Rotate the squeezing screw and push it into
the hole until it stops.
●
The lid cannot be closed if the squeezing
screw is not pushed down sufficiently.
●
Be careful not to get your finger clamped in
the gap between the squeezing screw and
the filter.
To assemble
4FUUIFKVJDJOHCPXMPOUIFNPUPS
housing.
Attach the rotating brush and filter,
then set it on the motor housing.
.PVOUUIFTRVFF[JOHTDSFX
2
3
4
Top view
Before Use
-Disassembly and assembly of the parts-
3FNPWFUIFKVJDF
attachment.
●
Squeezing screw comes out with it.
See page GB19 for how to install the gasket,
rubber plug and rubber brushes.
●
The juicer may not work properly if
they are not assembled correctly.
Squeezing
screw
Top view
Outer bottom view
Push it in until
no gap.
●
Rubber brushes are located on side of the
rotating brush.
●
Rubber plug is located outer bottom.
●
Gasket is located in the juicing bowl.
Filter
Rotating
brush
Remove the
KVJDJOHCPXM
from the motor
housing.
To disassemble
Disassembling/Assembling attachments
Make sure the gasket, rubber
plug and rubber brushes are
in place correctly.
Remove the parts.
1
2
3
1
(
)
Frozen
attachment
(
)
Frozen
attachment
●
The following steps show how to disassemble/assemble attachments, using the juice attachment as
an example.
The frozen attachment can be disassembled/assembled in the same method.
