6 Enter block commands in PANATERM
6
Enter block commands in PANATERM
To enter block commands, you need to start the block operation editor.
1. Connect your PC to the servo driver.
2. Start the PANATERM configuration software.
The software automatically detects the type of servo driver connected.
3. Select “OK” and confirm the connected series by selecting your type of servo driver.
4. Select “Other” > “Block operation Editor”.
5. In the “Selection of parameter to be read” dialog, select “Read the default”. There is
a message if the parameter values in the servo driver are not the default values. To
overwrite the parameters in the servo driver, select the “Trans” icon.
6. Double-click the first line in the table on the “Block operation edit” tab.
16
QS2001_V1.0_EN
