8. Reroute all wiring per original layout utilizing wire retainers
provided, and proper placement of wires to prevent
pinching of wires and interference when reinstalling the
indicator block assembly. Connect wires and apply wire
nuts, (reference WIRING DIAGRAM).
9. Install indicator block assembly. Holding the assembly at a
slight angle, insert the edge of the part behind the retaining
tabs (use T-shaped tab on assembly to align in slot of
retaining tab). With fingers lifting base off the floor (to free
front axle) use both thumbs to push the indicator block
assembly down until it snaps in place.
10. Install the overload protector by snapping into position
between the two retaining tabs and with one end pushed up
against the indicator block assembly.
11. Replace
remaining
parts
(see
Belt
Removal
&
Replacement).
3.4. AGITATOR BRUSH
3.4.1. Brush Checking
1. Replace the agitator brush if brushes are badly worn. Lay a
straight edge across the base supports and rotate the
agitator brush dowel. The brushes should extend past the
brush supports.
3.4.2. Agitator Assembly Replacement
1. Remove light cover and light lens, (see Bulb Removal &
Replacement).
2. Remove nozzle cover, (see Belt Removal & Replacement).
3. Remove old agitator assembly.
4. Discard the old agitator assembly.
5. Replace new agitator.
6. Replace the nozzle cover, screws and light cover, (see Belt
Removal & Replacement).
12
MC-V9644-00
