-9-
PARTS LIST
(MOTOR FAN ASSEMBLY)
1
2
3
4
5
6
7
8
EXPLODED VIEW
(MOTOR FAN ASSEMBLY)
Ref. No.
Part Name & Description
Part No.
Quantity
Remarks
1
Fan Case
AMC53F-AVØØU
1
2
Nut
AMC33F-ACØØU
1
3
Washer (a)
AMC62F-AVØØU
1
4
Fan
AC98FRFZØØ
1
5
Washer (b)
AC62FRFZØØ
1
6
Spacer
AC6ØFRFZØØ
1
7
Brush Assembly
AC27FRFZØØ
1(Set)
8
Bracket
AMCØ2D-V3ØØU
2
9
Screws
AMC4ØD-V3ØØU
4
-12-
LOWER PLATE REMOVAL/INSTALLATION
Removal
1.
Place the handle in upright position.
2.
Turn the vacuum cleaner over exposing the underside. Release the lower
plate by pressing the two (2) latches that secure it inward, (
Fig 1)
.
3.
Separate the lower plate from the vacuum.
Installation
1.
Hook the front of the lower plate into the slots on the front of the nozzle housing.
Press the lower plate down into place.
2.
Fasten the lower plate by pushing the two (2) latches outward.
NOTE: For general servicing, it is necessary to eliminate pinching of any
wire during reassembly. After servicing any electrical component or
electrical enclosure, the unit should be reassembled and checked
for dielectric breakdown or current leakage.
(Fig. 1)
AGITATOR ASSEMBLY REMOVAL/INSTALLATION
Removal
The brushes are replaceable separately. When the brushes need replacing, the
agitator assembly will have to be removed.
1.
Remove the lower plate as outlined in the LOWER PLATE REMOVAL/
INSTALLATION section.
2.
Carefully lift up on the agitator assembly until it clears both sides of the nozzle
housing, (
Fig. 2
).
3.
Remove the belt from the motor shaft by sliding it off between the end of the
shaft and the nozzle housing, (
Fig. 3
).
NOTE: The two (2) end caps may come off as you lift the agitator assembly
out. Look at the exploded view of the agitator assembly in the B Block
section for correct assembly of parts. The end caps can be reused.
Installation
1.
Place the belt around the motor shaft, (
Fig. 3
).
2.
Start the new agitator assembly back into the nozzle housing by placing the
side opposite the belt partially into the slot. This will hold the agitator in place,
and leave both hands free to place enough tension on the belt to allow that side
of the agitator to return to the nozzle housing slot.
3.
Place the belt around the agitator pulley on the agitator assembly.
Note: There is a place for the belt to fit on one end of the agitator
assembly only. This is the agitator pulley.
4.
Use both hands to pull the belt tight, (
Fig. 4
), and slide the agitator
assembly firmly into the slots on each end of the nozzle housing.
5.
Rotate the agitator assembly by hand to insure nothing rubs and to
check for correct assembly.
6.
Replace the lower plate as outlined in the LOWER PLATE REMOVAL/
INSTALLATION section.
(Fig. 2)
(Fig. 3)
(Fig. 4)
