To change the filter:
Remove the dust compartment (see page 9). Pull the top of the exhaust cover away from
the main body and lift off. Remove the filter, and insert the new one with the rubber seal towards the main body.
Locate the tab on the exhaust cover in the slot below the filter, then push the top of cover into place. Replace
the dust compartment (see page 9).
Main filter (Fig. 3) Part no. AMC8F39W5000
The main filter is located in the top of the dust cover compartment. Its function is stop dust particles from leaving
the dust compartment. Under normal usage, it will not require replacement. However it may become necessary to
clean or change it when vacuuming fine dust, such as talcum powder or similar materials over a period of time.
The filter should be replaced if the airflow through the dust compartment is insufficient.
To clean or change the filter:
Remove the dust cover .(see page 9)
Remove the dust cover top by pushing the tabs in and lifting off.
Clean dust accumulated in the
main filter by tapping it firmly
against a hard surface. Or install
a new filter if necessary.
Note: Rotate the filter until the
handle drops into the slots of the
filter support.
Re-assemble the dust cover by
aligning the tabs of the filter
support with the engraved zones
(claws) in the dust cover and
push together until the tabs
engage.
Put dust cover back onto dust
compartment and replace into the
main body (see page 9).
– 10 –
FILTER CARE
Central Filter (Fig. 1 )
Part no.: AMC8F03W5000
The central filter (foam filter), is located in the
main body under the dust compartment to
protect the motor from dirt.
Remove the dust compartment to gain access to
the central filter (see page 9).
To remove the central filter, hold the filter at the
top (as illustrated) and pull upwards.
Simply rinse out in warm water and dry
thoroughly before replacing.
When replacing, ensure that the hole in the
middle of the filter is located over the tab.
Replace the dust compartment (see page 9).
Important: Ensure that the filter is completely
dry before re-installing it into the cleaner.
Clean air filter HEPA Type (Fig. 2)
Part no.: AMC8S04W5000
The clean air filter is installed bellow the dust
compartment on the front of the cleaner.This
filter retains any small dust particles that may be
in the expelled air. Under normal usage, the
HEPA filter will not require replacement. It may
be necessary to change the filter if fine dust
such as talcum powder or similar material is
vacuumed over a period of time.
CAUTION: Never attempt to wash the HEPA filter.
IMPORTANT: Never use the cleaner without the correct filters properly installed. Failure to do so
may result in motor damage.
(Fig. 1)
(Fig. 2)
CAUTION: Never attempt to wash the main filter.
This will affect the performance of the cleaner.
(Fig. 3)
Tab
Tab
Slots
Filter
handle
