CAUTION: Do not pinch wire.
7. Install motor bridge and secure with two (2) screws.
8. Reroute all wiring per original layout utilizing wire retainers
provided, and proper placement of wires to prevent
pinching of wires and interference when reinstalling the
indicator block assembly. Connect wires and apply wire
nuts, (reference WIRING DIAGRAM).
9. Install indicator block assembly. Holding the assembly at a
slight angle, insert the edge of the part behind the retaining
tabs (use T-shaped tab on assembly to align in slot of
retaining tab). With fingers lifting base off the floor (to free
front axle) use both thumbs to push the indicator block
assembly down until it snaps in place.
10. Install the overload protector by snapping into position
between the two retaining tabs and with one end pushed up
against the indicator block assembly.
11. Replace remaining parts (see BELT REMOVAL).
3.4. AGITATOR ASSEMBLY
3.4.1. Agitator Checking
1. When brushes are worn to the level of the base support
bars, replace the agitator.
3.4.2. Agitator Assembly Replacement
1. Remove Power Nozzle cover, agitator cover, belt and
agitator assembly (see BELT REMOVAL).
2. Reassemble belt, agitator assembly, Power Nozzle cover,
light bulb and light cover (see BELT REPLACEMENT).
13
MC-CG973-00
