7.4.1-8. Simple Resolution Real Time Adjustment
The Simple Resolution Real Time Adjustment is useful for models which are equipped with adjustment pins
on the 1st Lens frame unit.
When rotating the
2 Adjustment pins
with Torx Driver (RFKZ0609), corresponding results are displayed on the
PC monitor in real time.
※
Check the adjusted visual result on the monitor.
7.4.1-8.1. Procedure of Simple Resolution Real Time Adjustment
(1)
(2)
(3)
(4)
the Adjustment pins.
(5)
(6)
After above adjustment with real time mode has successfully been completed, perform inspection with
Still mode. (Refer to "
7.4.1-7. Simple Resolution Inspection with Still Mode
")
* If the result is all OK, skip "
7.4.2. 1st Lens Frame Adjustment (Projector method)
" and move on
to the "
7.4.3. Electrical Adjustment
".
* If result is NG, perform adjustment with single mode, repeating "taking a picture - inspection -
- adjustment" as a cycle.)
As for Adjustment conditions/procedure, consult the "Operating Instructions" which is available in software package.
Click the Still/Real time slide switch to "Real-Time" (left) side.
The chart image will be displayed on the PC monitor in real time.
try changing the “DeviceNum” to 0, 1 or 2.
Green frames indicate the measurement range, which can be
Check measurement environment and/or settings again.
If there is/are “NG” in graphic indicators, the lens doesn't meet standard.
widened or narrowed.
*If no image is displayed and/or displayed from other camera sources),
Corresponding image result are displayed in real time when rotating
Adjust the Adjustment pins until all items are displayed as OK(Green).
Since the pins/lens are sensitive,
rotate them little by little.
( About 5~30 degrees )
Graphic indicator
Numerical value
Adjustment Pin
1st Lens Frame
Adjustment Pin
Adjustment Pin
1st Lens Frame
Torx driver (RFKZ0609)
27
