Panasonic LP-GS Series, Руководство по установке и обслуживанию

Страница: 30 / 190

30
„
Rear
6
7
5
4
3
1 9
8
10
11
12
13
2
1. Ethernet port: LAN
The port to connect the LAN cable used when connecting the laser marker with the following devices via Ethernet.
• The PC with Laser Marker NAVI smart installed
• PLC or PC for control: Externally controls the laser marker using the communication commands.
• Specified external devices: Interfaces the specified external device (image reading equipment) with the laser marker
and controls their operations.
2. USB port B: USB
This is the connector for connecting the attached USB cable. When you connect the laser marker configuration
software Laser Marker NAVI smart online, connect this cable to the PC.
3. RS-232C port: RS-232C
The port to connect the following external devices for the serial communication control of the laser marker using RS-
232C.
• PLC or PC for control: Externally controls the laser marker using the communication commands.
• Code reader compatible with the RS-232C communication: Modifies the data to mark by the laser marker according
to the code details read by the code reader.
4. Signal connector: SIGNAL
This is the terminal for communicating between head and controller. Connect the attached signal cable.
5. Power connector: POWER
This is the connector for supplying the power to the head. Connect the attached unit power cable.
6. I/O terminal block: TERMINAL
The terminal block to connect I/O signals used for the external control of the laser marker.
Connect the attached terminal block.
Refer to “4-2 Signals and Details of I/O Terminal Block” (P.70) for details.
7. I/O connector: I/O
The connector to connect I/O signals used for the external control of the laser marker.
For details, refer to “4-3 Signals and Details of I/O Connector” (P.78).
ME-LPGS-SM-8