Panasonic Lamdash ES-BST6Q, Руководство по эксплуатации

Страница: 12 / 72

12
English
Making foam
ES-BST6Q
It is easier to make foam this way than by hand.
1
1
Take an appropriate amount of
facial cleanser etc� in the palm
of your hand�
2
2
Add an appropriate amount of
water or hot water�
3
3
Hold the power switch for
2 seconds or more to switch to
shaving foam mode�
The switch lock lamp ( )
and charge status lamp ( )
blink alternately.
•The shaving foam mode ends after 15 seconds. The shaver
can then be used to shave.
•To stop using the shaving foam mode and start shaving,
press the power switch once.
•When the switch lock lamp ( ) blinks after the power switch is
pressed, the shaver will not operate as it is locked. Press the
power switch for more than 2 seconds to unlock. (See page 14.)
4
4
Press the blades gently in the
palm of your hand, mix the
facial cleanser etc� around and
move the blades up and down
to make foam.
• If there is insufficient foam, add slightly
more water, hot water or facial cleanser
etc. to make it easier to create foam.
► Notes
•Before making foam, check that the blades are not broken or
deformed, and that the cleaning shutter is closed.
•Do not use shaving agent (excluding foam), facial cleansing
foam (with scrubbing compounds) or soap as these may cause
the blades to clog, or be unable to make foam.
Shaving
1
1
Press and shave�
•The power cannot be turned on when the
switch lock lamp ( ) blinks, as the
power switch is locked.
Press the power switch for more than
2 seconds to unlock. (See page 14.)