10.2 Display messages
To indicate the unit’s status, one or more of the following messages will appear on the display.
Display
Cause & Solution
“
CALL SERVICE
”
R
There is something wrong with the unit. Contact our service personnel.
“
CHANGE DRUM
”
R
There is something wrong with the drum cartridge. Replace the drum
cartridge and the toner cartridge.
“
CHECK DOCUMENT
”
R
The document was not fed into the unit properly. Remove the document,
and then press
M
Stop
N
to clear the message. Re-insert the document. If
misfeeding occurs frequently, clean the document feeder rollers
(page 98) and try again.
“
CHECK DRUM
”
R
The drum cartridge is not inserted properly. Re-insert it correctly (page 10).
“
CHECK PAPER #1
”
R
Recording paper is not installed or the paper input tray has run out of paper.
Install paper (page 14).
R
Recording paper was not fed into the unit properly. Re-insert the recording
paper (page 92).
R
The paper input tray is not installed or is not inserted completely. Insert the
paper input tray into the unit.
“
CHECK PAPER TRAY #1
”
R
The loaded recording paper is not the appropriate size. Load recording
paper of the size that is shown on the display.
R
If this message is often displayed, also change the recording paper size
setting (feature #380 on page 58).
R
The recording paper size setting (feature #380 on page 58) is set to
“
B5(ISO)
”
,
“
B5(JIS)
”
or
“
16K
”
, so received faxes have been stored into
memory. Change the recording paper size setting and load the appropriate
recording paper.
Note:
R
“
#1
”
: Check the paper input tray. The displayed paper size depends on the
recording paper size setting (feature #380 on page 58).
R
“
#2
”
: Check the manual input tray. The displayed paper size depends on
the recording paper size setting (feature #381 on page 58).
“
CHECK PICK UP INPUT
TRAY #2
”
R
Recording paper was not fed into the unit properly. Load the paper again
(page 92).
“
CHECK REAR COVER
”
R
The manual input tray (rear cover) is open. Close it.
R
A recording paper jam occurred near the manual input tray (rear cover).
Remove the jammed paper (page 88).
“
COOL DOWN FUSER
”
R
The unit is cooling down the fuser unit. Wait for a while.
“
DRUM LIFE LOW REPLACE
SOON
”
R
The drum is reaching the end of its life. Replace the drum cartridge and the
toner cartridge as soon as possible.
“
EMAIL SIZE OVER
”
R
When performing scan to email address, the total file size of scanned data
exceeded the file size limitation. Divide the document into sections.
77
10. Help
Содержание KXMB2000E
Страница 117: ...117 Notes ...
Страница 118: ...118 Notes ...
Страница 119: ...119 Notes ...
Страница 120: ... MB2000E MB2000E PNQX2626ZA CM1209SY0 CD ...