*4 When the cellular line only mode is turned on, these menus are not displayed (page 19).
*5 After the Bluetooth device is paired, the device name is displayed.
*6 For CELL 1
*7 For CELL 2
*8 The preset melodies in this product are used with permission of © 2012 Copyrights Vision
Inc.
*9 The preset melodies in this product are used with the following permission:
–
“
Tone 1
”
and
“
Tone 2
”
: © 2013 Copyrights Vision Inc.
–
“
Tone 3
”
-
“
Melody 10
”
: © 2012 Copyrights Vision Inc.
*10 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select
“
Caller ID auto
”
. To turn this feature off, select
“
Manual
”
. (Call Display subscribers only)
To use this feature, set the date and time first (page 15).
*11 If you subscribe to a distinctive ring service, select a tone (tone 1 or 2). If you select a
melody, you cannot distinguish lines by their ringers.
*12 This tone lets you know when you receive an outside call while you are on another line or an
intercom call. If you select
“
On
”
, the tone sounds 2 times.
*13 This setting is available when you have the key detector (KX-TGA20). Read the installation
manual for more information on the key detector.
*14 For models with supplied key detectors, the display shows “
1:
Detector1
”.
*15 If you register 2 or more key detectors.
*16 If you have 2 or more key detectors.
*17 If you subscribe to a Call Display service and want to view the caller’s information after lifting
up the handset to answer a call, turn off this feature.
*18 The flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary.
*19 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to
“
A
”
if telephone line condition is not good.
Alarm
An alarm sounds at the set time for 1 minute
and is repeated 5 times at 5 minute intervals
(snooze function). A text memo can also be
displayed for the alarm. A total of 3 separate
alarm times can be programmed for each
handset. You can set one of 3 different alarm
options (once, daily, or weekly) for each alarm
time.
Important:
R
Make sure the unit’s date and time setting
is correct (page 15).
1
M
MENU
N#720
2
Select an alarm by pressing
1
to
3
.
a
M
SELECT
N
3
MbN
: Select the desired alarm option.
a
M
SELECT
N
“
Off
”
Turns alarm off. Go to step 10.
“
Once
”
An alarm sounds once at the set time.
“
Daily
”
An alarm sounds daily at the set time.
Go to step 5.
“
Weekly
”
Alarm sounds weekly at the set time(s).
43
Programming
TGE26x_27xC(en)_1224_ver012.pdf 43
2013/12/24 15:43:31
