Programming
33
Megjegyzés:
L
Calls are disconnected when the handset
moves from one radio cell to another.
Registering a handset to a base
unit
The supplied handset and base unit are pre-
registered. If for some reason the handset is
not registered to the base unit (for example,
_
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
1
(middle soft key)
(
13
)
2
{
r
}
: Select a base unit number.
s
M
L
This number is used by the handset
as a reference only.
3
Base unit:
Press and hold
{x}
for about 5 seconds.
(No registration tone)
L
If all registered handsets start ringing,
press
{x}
again to stop, then repeat
this step.
L
The next step must be completed
within 90 seconds.
4
Handset:
M
s
Wait until
“
Bázis PIN
”
is
displayed.
s
Enter the base unit PIN
(default:
“
0000
”
).
s
M
L
If you forget your PIN, contact an
authorised service centre.
L
When the handset has been
registered successfully,
w
is
displayed.
Megjegyzés:
L
While registering,
“
Bázisállomás
regisztráció
”
is displayed on all
registered handsets.
L
When you purchase an additional
handset, refer to the additional handset’s
installation manual for registration.
Selecting a base unit
When
“
Automata
”
is selected, the handset
automatically uses any available base unit it
is registered to. When a specific base unit is
selected, the handset makes and receives
calls using that base unit only. If the handset
is out of range of that base unit, no calls can
be made.
1
1
(middle soft key)
(
137
2
{
r
}
: Select the desired base unit
number, or
“
Automata
”
.
s
M
L
The handset starts searching for the
base unit.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset
to end its wireless connection with the
system.
1
1
(middle soft key)
(
131
L
All handsets registered to the base
unit are displayed.
2
{
r
}
: Select the handset you want to
cancel.
s
M
3
{
r
}
:
“
IGEN
”
s
M
L
A confirmation tone sounds.
L
The handset does not beep when
cancelling its own registration.
4
{i
c
}
Cancelling a base unit
A handset can cancel a base unit that it is
registered to. This allows the base unit to end
its wireless connection with the system.
1
1
(middle soft key)
(
139
2
{
r
}
: Select the base unit you want to
cancel.
s
M
3
{
r
}
:
“
IGEN
”
s
M
s
{i
c
}
Megjegyzés:
L
To register a handset to another base unit
or to the same base unit again, see 33.
oldal.
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
TG8611PD(e-hg).book Page 33 Friday, March 18, 2011 1:31 PM