Useful Information
46
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC
adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the handset.
General use
Programmable settings
Problem
Cause/solution
The handset does not turn on
even after installing charged
batteries.
L
Place the handset on the base unit or charger to turn on the handset.
The unit does not work.
L
Make sure the batteries are installed correctly (10. oldal).
L
Fully charge the batteries (11. oldal).
L
Check the connections (10. oldal).
L
Unplug the base unit’s AC adaptor to reset the unit and turn off the
handset. Reconnect the adaptor, turn on the handset and try again.
L
The handset has not been registered to the base unit. Register the
handset (30. oldal).
The handset display is blank
or dark.
L
The handset is in screen saver mode (15. oldal). Activate the handset
display again by:
– pressing
{
<
}
or
{
>
}
when on a call.
– pressing
{i
c
}
at all other times.
L
“
LCD töltésnél
”
is set to
“
KI
”
while on charge. Change the
setting (26. oldal).
L
The handset is not turned on. Turn the power on (15. oldal).
I cannot hear a dial tone.
L
Make sure that you are using the supplied telephone line cord. Your
old telephone line cord may have a different wiring configuration.
L
The base unit’s AC adaptor or telephone line cord is not connected.
Check the connections.
L
Disconnect the base unit from the telephone line and connect the line
to a known working telephone. If the working telephone operates
properly, contact our service personnel to have the unit repaired. If
the working telephone does not operate properly, contact your
service provider/telephone company.
Problem
Cause/solution
The display is in a language
I cannot read.
L
Change the display language (15. oldal).
While programming, the
display returns to standby
mode.
L
A call matching an entry in the call barred list is being received. Wait
and try again later.
I cannot activate the eco
mode.
L
You cannot set eco mode when you set the repeater mode
“
BE
”
. If
required, set the repeater mode to
“
KI
”
(30. oldal).
TG8051_8061PD(e-hg).book Page 46 Wednesday, February 2, 2011 2:33 PM