Changing the unit’s region
setting/Resetting the base unit
Important:
R
When you install the batteries for the
first time, the handset may prompt
you to set region setting. First press
M
SELECT
N
, then proceed to step 2.
1
M
MENU
N#136
2
MbN
: Select the desired country.
a
M
SELECT
N
“
Australia
”
= Australia
“
Newzealand
”
= New Zealand
3
MbN
:
“
Yes
”
a
M
SELECT
N
a
M
OFF
N
Note:
R
The following items will be deleted or
reset to their default settings:
– Answering system settings
(page 29)
– Time adjustment
– Base unit ringer volume
– Landline area code
– Line mode
– Privacy mode
– Bluetooth settings (page 32)
– Group ringer tone
– Talking Caller ID (Base unit setting
only)
– Caller list
– Voice mail messages and access
number
– Cellular phones settings (Base unit
setting only) (page 31)
R
The following items will be retained:
– Date and time
– Shared phonebook
– Handset name
– Repeater mode
– Recordings, including your greeting
message, and caller messages
– Call screening
– Call barred list
– Cellular phones registration
– Headset registration
R
If you select the desired country in
step 2, the following default setting will
be changed for the selected country’s
default setting:
– Recall time (page 34)
R
After changing the unit’s region
setting/resetting the base unit, is
displayed on the handset
momentarily. This is normal and the
handset can be used once is
displayed.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to
the base unit.
Important:
R
See page 5 for information on the
available model.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base
unit, re-register the handset.
1
Handset:
M
MENU
N#130
2
Base unit:
Press and hold
M
LOCATOR
N
for
about 5 seconds until the
registration tone sounds.
R
If all registered handsets start
ringing, press
M
LOCATOR
N
again
to stop, then repeat this step.
R
The next step must be completed
within 90 seconds.
3
Handset:
Press
M
OK
N
, then wait until a long
beep sounds.
38
Programming
TG76xxAZ(en)_0207_ver012.pdf 38
2012/02/07 15:34:47
