![background image](http://html.mh-extra.com/html/panasonic/kx-tg6561bxt/kx-tg6561bxt_service-manual_1512350052.webp)
52
KX-TG6561BXT/KX-TGA651BXT
11 Measurements and Adjustments
This chapter explains the measuring equipment, the JIG connection, and the PC setting method necessary for the measurement in
11.1. Equipment Required
• Digital multi-meter (DMM): it must be able to measure voltage and current.
• Oscilloscope.
• Frequency counter: It must be precise enough to measure intervals of 1 Hz (precision; ±4 ppm)
Hewlett Packard, 53131A is recommended.
• DECT tester: Rohde & Schwarz, CMD 60 is recommended.
This equipment may be useful in order to precisely adjust like a mass production.
11.2. The Setting Method of JIG (Base Unit)
This section explains the PC setting to use command required in
<Preparation>
• Serial JIG cable: PQZZ1CD300E*
• PC which runs in DOS mode
•
Batch file CD-ROM
for setting: PNZZTG6561BX
Note:
*: If you have the JIG Cable for TCD500 series
(PQZZ1CD505E), change the following values of
resistance. Then you can use it as a JIG Cable for both
TCD300 and TCD500 series. (It is an upper compatible JIG
Cable.)
11.2.1. Connections
Connect the AC adaptor to DC-JACK (base unit).
Connect the JIG Cable GND (black) to GND.
Connect the JIG Cable RX (red) to URX and TX (yellow) to UTX.
Note:
*: COM port names may vary depending on what your PC calls it.
Resistor
Old value (k
Ω
)
New value (k
Ω
)
R2
22
3.3
R3
22
3.3
R4
22
4.7
R7
4.7
10
1
2
3
Ba
s
e unit P. C. board
UTX (yellow)
AC
a
d
a
ptor
1
2
3
3
URX (red)
GND (
b
l
a
ck)
To
S
eri
a
l Port
(COM port 1
*
)
JIG C
ab
le
PC
GND UTX URX
Содержание KX-TG6561BXT
Страница 73: ...73 KX TG6561BXT KX TGA651BXT Memo ...
Страница 76: ...76 KX TG6561BXT KX TGA651BXT Memo ...
Страница 85: ...85 KX TG6561BXT KX TGA651BXT 15 3 Accessories A1 A2 ...
Страница 90: ...90 KX TG6561BXT KX TGA651BXT RAD KXTG6561BXT KXTGA651BXT ...