Panasonic KX-TG6461AL, Руководство по эксплуатации

Страница: 26 / 52

Programming
26
unit settings, handset settings, etc.) may not be
available.
Registering a handset to the base
unit
The supplied handset and base unit are pre-
registered. If for some reason the handset is not
registered to the base unit (for example,
w
flashes
even when the handset is near the base unit), re-
register the handset.
1
Handset:
8
(middle soft key)
2
{V}
/
{^}
: “
Handset Setup
”
i M
3
{V}
/
{^}
: “
Register H.set
”
i M
4
Base unit:
Press and hold
{x}
for about 5 seconds, until
the registration tone sounds.
L
If all registered handsets start ringing, press
the same button to stop. Then repeat this
step.
L
The next step must be completed within 90
seconds.
5
Handset:
Wait until “
Base PIN
” is displayed.
i
Enter
the base unit PIN (default: “
0000
” ).
i M
L
If you forget your PIN, contact an authorised
service centre.
L
When the handset has been registered
successfully,
w
stops flashing.
Note:
L
When you purchase an additional handset, refer
to the additional handset’s installation manual
for registration.
Deregistering a handset
A handset can cancel its own registration (or the
registration of another handset) that is stored to
the base unit. This allows the handset to end its
wireless connection with the system.
1
8
(middle soft key)
2
{V}
/
{^}
: “
Base Unit Setup
”
i M
3
{
3
}{
3
}{
5
}
4
{V}
/
{^}
: “
Cancel Register
”
i M
L
The numbers of all handsets registered to
the base unit are displayed.
5
Select the handset(s) you want to cancel by
pressing the desired handset number.
i
M
L
The selected handset number(s) flashes.
L
To cancel a selected handset number,
press the number again. The number stops
flashing.
6
{V}
/
{^}
: “
Yes
”
i M
L
A confirmation tone sounds as each
handset number disappears.
L
The handset does not beep when
cancelling its own registration.
7
{ih}
Increasing the range of the base unit
You can increase the signal range of the base unit
by using a DECT repeater. Please use only the
Panasonic DECT repeater noted on page 3.
Contact your Panasonic dealer for details.
Important:
L
Before registering the repeater to this base unit,
you must turn the repeater mode on.
L
Do not use more than one repeater at a time.
Setting the repeater mode
1
8
(middle soft key)
2
{V}
/
{^}
: “
Base Unit Setup
”
i M
3
{V}
/
{^}
: “
Repeater
”
i M
4
{V}
/
{^}
: Select the desired setting.
i M
i
{ih}
Note:
L
After turning repeater mode on or off, certain
icons displayed on the base unit disappears for
a moment and
w
flashes on the handset
momentarily. This is normal and the handset can
be used once
w
stops flashing.
Y
Handset
Y
Handset
TG6461AL(e).book Page 26 Tuesday, June 23, 2009 8:48 AM