48
Troubleshooting
If the handset display shows error messages, see “If the Following Appear on
Your Display...” (p. 47) for the Cause & Remedy.
Problem
Cause & Remedy
“
No link to base.
Move closer to
base and try
again.
” is displayed and an
alarm tone sounds.
•
You are too far form the base unit. Walk
closer to the base unit, and try again.
•
Confirm the base unit’s AC adaptor is
plugged in.
•
Raise the base unit antennas.
•
If the above remedies do not solve the
problem, the handset may have lost
communication with the base unit. Register
the handset again (p. 40).
The handset and/or base unit
does not work.
•
Check the settings (p. 9–11).
•
Check whether the dialing mode setting is
correct (p. 14).
•
Fully charge the battery (p. 10).
•
Clean the charge contacts and charge again
(p. 11).
•
Check battery installation (p. 10).
•
Unplug the base unit’s AC adaptor to reset it.
Plug in, and try again.
•
Re-install the battery (p. 10) and fully charge
it.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
•
Move the handset and base unit away from
other electrical appliances (p. 3).
•
Walk closer to the base unit.
•
Raise the base unit antennas.
•
Turn on the Clarity Booster feature (p. 21).
The handset does not ring.
•
The ringer volume is turned off. Set to high,
medium, or low (p. 16).
The handset display is blank.
•
If the handset display is blank, fully charge
the battery (p. 10).
You cannot program any
function items.
•
Programming is not possible while the
handset is being used.
•
Do not pause for over 60 seconds while
programming.
•
Walk closer to the base unit.
While programming or
searching, the handset starts
to ring and the program/
search stops.
•
A call is coming in. To answer the call, press
[
C
]
or
[
s
]
.
Start again from the beginning
after hanging up.
