Things You Should Know
Section 6
6-E Before Requesting Help
Problem
The unit does not work.
An alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The unit does not ring.
Remedy
•
Check the settings (1-C).
•
Charge the battery fully (6-A).
•
Clean the charge contacts and charge
again (6-A).
•
Install the battery properly (6-B).
•
Place the handset on the base unit and
unplug the AC adaptor to reset. Plug in,
and try again.
•
Re-install the battery and place the
handset on the base unit. Try again.
•
KX-TG2503ALF/KX-TG2503NZF are not
designed to be used with rotary (pulse
dialling) services.
•
You are too far from the base unit. Move
closer and try again.
•
Place the handset on the base unit and try
again.
•
Make sure the AC adaptor is connected to
the base unit.
•
Raise the base unit antennas.
•
Locate the handset and the base unit
away from other electrical appliances
(6-C).
•
Move closer to the base unit.
•
Raise the base unit antennas.
•
Press
(CH)
to select a clearer channel.
•
The ringer volume is set to OFF. Press
Ñ
or
Ö
while the TALK indicator light is off
(2-B).
Problem
While storing a phone
number, the unit starts to
ring.
You cannot store a
phone number in
memory.
Previously programmed
information is erased.
You cannot redial by
pressing
(REDIAL)
.
(HANDSET!LOCATOR)
does
not function.
The RECHARGE
indicator flashes or the
unit beeps intermittently.
You charged the battery
fully, but the RECHARGE
indicator flashes.
The IN USE/CHARGE
indicator light does not
go out while charging.
Remedy
•
To answer the call, press
(TALK)
. The
program will be cancelled. Store the
number again.
•
You cannot store a number while the unit
is in the talk mode.
•
Do not pause for over 60 seconds while
storing.
•
If a power failure occurs, programmed
information may be erased. Reprograme if
necessary.
•
If the last number dialled was more than
32 digits long, the number will not be
redialled correctly.
•
The handset is too far from the base unit
or is engaged in an outside call.
•
Charge the battery fully (6-A).
•
Clean the charge contacts and charge
again (6-A).
•
Install a new battery (6-B).
•
This is normal.
6-F Wall Mounting
1
Adjust the angle of the cradle:
#
Slide the lock switch
to “RELEASE”.
$
Rotate the cradle 90°
until it faces straight
up.
%
Slide the lock switch
to “LOCK” with the
cradle facing straight
up.
2
Connect the AC adaptor.
3
#
Tuck the telephone line
cord inside the wall
mounting adaptor.
$
Connect the telephone
line cord to the unit.
%
Install the adaptor by
pushing it in the
direction of the arrow.
•
The word “UP” should
face upward.
4
Install screws using
the wall template.
Connect the
telephone line
cord. Mount the
unit, then slide
down.
•
Raise the antennas.
1
3
Back Side
Back Side
2
To Power
Outlet
2
3
1
Screws
8.3 cm
For Australia
To Telephone Plug
connected to Socket
OR
For New Zealand
To Single-Line
Telephone Jack
This unit can be mounted on a wall.
8.3 cm
Wall Template
