Programmable Functions
12
Date and Time
“
” flashes on the base unit display if the clock has not been
set. Set the clock by following the steps below.
• When entering the time in step 3, you cannot enter numbers greater than 12.
Do
not use military time.
(To set 13:00 hours, enter “0100”, then select “
PM
” in
step 4.)
To check the date/time,
repeat steps 1 and 2 above.
• The current date/time is displayed. When finished, press
[OFF]
.
1
Press
[MENU]
.
2
Scroll to “
Date and time
” by pressing
[ ]
or
[ ]
, then press
Select
.
3
Enter 2 digits each for month, day, and
year. (Ex. To set Apr. 7, 2003, enter “04 07
03”.)
Enter 4 digits for time (hour and minute). (Ex.
To set 9:30, enter “0930”.)
• If you enter a wrong number, press
[
]
or
[
]
to
move the cursor to the incorrect number. Enter the
correct number.
4
Select “
AM
” or “
PM
” by pressing
AM/PM
.
5
Press
Save
, then press
[OFF]
.
• The clock is set and “
” disappears from the
base unit.
• If 3 beeps sound after pressing
Save
, the setting
is not correct. Start again from step 3.
If a power failure occurs, the time setting may be incorrect. When “
” flashes
on the base unit display, adjust the date/time.
For Caller ID service users (p. 25)
• Caller ID information will reset the clock after the first ring if the adjusted time is
incorrect.
• If the time has not previously been set, Caller ID information will not adjust the
clock.
• Caller ID information will automatically adjust the clock for daylight saving time.
Handset
>
>
Date and time
Exit
Select
>
>
1
2
>
>
Date:12.31.2003
Time:12:00 AM
AM/PM Save
Date:04.07.2003
Time:09:30 AM
AM/PM Save
Example
1
0
Date:04.07.2003
Time:09:30 AM
AM/PM
Save
0
