44
Troubleshooting
Problem
Cause & Remedy
The unit does not work.
• Check the settings (p. 8–9).
• Check whether the dialing mode setting is
correct (p. 12).
• Charge the battery fully (p. 8).
• Clean the charge contacts and charge again
(p. 9).
• Install the battery properly (p. 8).
• Place the handset on the base unit and
unplug the AC adaptor to reset it. Plug in, and
try again.
• Re-install the battery (p. 8) and charge it fully.
“
No link to base. Place
on cradle and try
again.
” is displayed and an
alarm tone sounds.
• You are too far from the base unit. Walk
closer and try again.
• Place the handset on the base unit and try
again.
• Plug in the AC adaptor.
• Raise the base unit antenna.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
• Move the handset and the base unit away
from other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• Select a clearer channel (p. 19, 34).
The handset and/or base unit
does not ring.
• The ringer volume is set to OFF. Set to HIGH,
MEDIUM or LOW (p. 16).
• When the handset is on the base unit, the
handset does not ring. Only the base unit
rings when receiving a call.
The handset display is blank.
• Charge the battery fully (p. 8).
You cannot program function
items.
• Programming is not possible while the unit is
being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
Previously programmed
information is erased.
• If a power failure occurs, programmed
information may be erased. Reprogram if
necessary.
✿✤✦✩✫✩✿✮❃ ✧✧
