Panasonic KX-TDE100, Руководство по функциям

Страница: 208 / 392

5.
It is strongly recommended that passwords of 10 numbers or characters be used for maximum
protection against unauthorized access. For a list of numbers and characters that can be used in system
passwords, refer to Section 1.1.2 Entering Characters in the PC Programming Manual.
6.
If a system password is forgotten, it can be found by loading a backup of the system data into a PC,
and checking the password using the Maintenance Console software. If you do not have a backup of
the system data, you must reset the PBX to its factory defaults and reprogram it. Therefore, we strongly
recommend maintaining a backup of the system data. For more information on how to back up the
system data, refer to the PC Programming Manual.
However, as system passwords can be extracted from backup copies of the system data file, do not
allow unauthorized access to these files.
PC Programming Manual References
1.1.2 Entering Characters
2.1.2 Access Levels
13.1 [11-1] Main—Password
Feature Manual References
21.1 Capacity of System Resources
13.1.4 Pause Insertion
Description
Pressing a PAUSE button inserts a preprogrammed Pause time between digits of a user-dialed number before
the number is dialed out, allowing certain numbers separated with a pause to be used to access certain features
(e.g., access codes, seizing idle lines, etc.).
When a pause is needed, pauses must be inserted manually (pressing the PAUSE button) in all cases, except
for the following access codes where a pause is automatically inserted between the user-dialed access code
and the subsequent digits:
a.
Host PBX Access code (
®
8.1.5 Host PBX Access Code (Access Code to the Telephone Company from
a Host PBX))
b.
Special Carrier Access code (
®
16.1.5 Special Carrier Access Code)
c.
Second Dial Tone Waiting code
Conditions
•
The length of a pause is programmable for each CO line.
•
Numbers stored in Memory Dialing can contain pauses.
•
When a Second Dial Tone Waiting code is dialed after seizing a CO line, a preprogrammed number of
pauses are inserted after the code.
•
ARS
A pause is not automatically inserted between the user-dialed access code and the subsequent digits when
the ARS mode is enabled. (
®
1.1.3 ARS (Automatic Route Selection))
PC Programming Manual References
3.30 [1-1] Slot—Port Property - LCO Port— Pause Time
3.36 [1-1] Slot—Port Property - T1 Port— Pause Time
4.5 [2-3] Timers & Counters—Miscellaneous— During Conversation—Pause Signal Time
208 Feature Manual Document Version 2009-12
13.1.4 Pause Insertion