Panasonic KX-TDA30, Руководство по установке

Страница: 31 / 264

AC Adaptor Selection (Without BRI Extension Port)
You must connect an additional AC adaptor in any of the following conditions:
•
A total of more than 4 APTs, DPTs (except KX-DT300 series/KX-T7600 series/KX-T7560/KX-T7565), and
DSS consoles (except KX-DT300 series/KX-T7600 series) are connected.
•
More than 4 CSs are connected.
•
An MEC card is required to support a configuration with a total MEC figure exceeding 28.
•
Both the DID3 card and the SLC4 or DLC4 card are installed in any of Slots 2 to 4.
Note
For how to connect an AC adaptor or additional AC adaptor, refer to "2.13.1 Starting the PBX".
AC Adaptor Selection (With BRI Extension Port)
If the PBX has a BRI extension port, you must connect an additional AC adaptor in any of the following
conditions:
•
A total of more than 4 APTs, DPTs (except KX-DT300 series/KX-T7600 series/KX-T7560/KX-T7565), and
DSS consoles (except KX-DT300 series/KX-T7600 series) are connected.
•
More than 4 CSs are connected.
•
An MEC card is required to support a configuration with a total MEC figure exceeding 28.
•
Both the DID3 card and the SLC4 or DLC4 card are installed in any of Slots 2 to 4.
•
The total load figure exceeds 32.
Note
For how to connect an AC adaptor or additional AC adaptor, refer to "2.13.1 Starting the PBX".
Load Figure Calculation
Equipment Type Load Figure
PT KX-DT300 series DPT/KX-DT300 series DSS
console/KX-T7600 series DPT/KX-T7600 ser-
ies DSS console 0
KX-T7560/KX-T7565 DPT 0
Other DPT/Other DSS console 4
APT 4
IP-PT 0
Pre-installed 4 Super Hybrid Ports 0
Extension Card SLC4 0
SLC8 0
CS (1 unit) 4
High-density CS (1 unit) 8
VPS (1 port) 0
ISDN Telephone 1
*1
*1 If the connected ISDN telephone has an external power source, its load figure is 0.
Installation Manual 31
1.4.3 System Capacity