Summary of Programming Features
33
Chapter 3
Advanced Operations
This unit has base unit programming and handset programming modes.
Be sure that the power is ON (p. 16), you are in the stand-by mode, and the
handset is near the base unit. See the noted pages for details.
The base unit program mode has the following functions.
•
To set the Dialling Mode, see page 17.
•
To set the Pause Timing, see page 29.
•
To set the FLASH/EARTH Mode, see page 31.
•
To change the Base Unit Password, see page 35.
•
To set the Call Restriction, see page 38.
•
To clear the Settings in Base Unit Memory, see page 46.
•
To cancel a Handset, see page 50.
•
To select "Cyclic", see page 54.
•
To select the Handset(s), see page 55.
•
To select the First Handset, see page 56.
•
To select All Handsets, see page 57.
•
To clear Redial Memory, see page 22.
•
To set the Receiver Volume, see page 24.
•
To set the Handset Ringer Volume, see page 25.
•
To change the Handset Password, see page 34.
•
To set the Call Prohibition, see page 36.
•
To set the Direct Call Mode, see page 40.
•
To select the Talk Mode Display, see page 42.
•
To set the Handset Ringer Pattern, see page 43.
•
To set the Key Tones, see page 43.
•
To set the Range Warning Alarm, see page 44.
•
To set the Battery Low Alarm, see page 44.
•
To clear the Settings in Handset Memory, see page 45.
•
To register a Handset in the Base Unit, see page 48.
•
To cancel a Base Unit, see page 51.
•
To select the Stand-by Mode Display, see page 52.
•
To set the Call Waiting Tone, see page 61.
•
To set the Base Unit Access, see page 69.
The handset program mode has the following functions.
Helpful hints for programming
•
To cancel during programming, press
(Program), then start from the
beginning.
•
If 5 beeps sound during programming, a wrong key was pressed.
Enter the correct number again.
•
To return to the previous step during programming halfway, press
(Cancel).
KX-TCD950E(E)(23~44) 98.6.25 4:59 PM Page 33
