Panasonic KX-TCA256X, Руководство по обслуживанию

Страница: 7 / 61

7
KX-TCA256X
4.2. Circuit Operation (Handset)
4.2.1. Outline
Handset consists of the following ICs as shown in Block Diagram (Handset) (P.6).
• DECT BBIC ( B ase B and IC): IC201
- All data signals (forming/analyzing ACK or CMD signal)
- All interfaces (ex: Key, Detector Circuit, Charge, DC/DC Converter, LCD)
Include EEPROM and Flash memory
EEPROM stores the temporary operating parameters (for RF, etc.)
• AMP: IC401
- Single OP_AMP for SP
• MIDI: IC301
- 16-Tone 32-Poly PCM Sound Generator
- Port (LED direct driver with PWM)
• RF Block
- IC601
PLL Oscillator
Detector
Compress/Expander
Amplifier for reception
- IC602
Amplifier for transmission
Power control
4.2.2. Power Supply Circuit/Reset Circuit
Circuit Operation:
When power on the Handset, the voltage is as follows;
BATTERY(3.5V~4.2V: )
→
Q104 (1.8V)
→
Q105 (2.7V)
The Reset signal generates IC201 (78) and 1.8V.
4.2.3. Charge Circuit
Circuit Operation:
When charging the handset on the charger, the charge current is as follows;
DC+(9V~10V)
→
IC601(6)
→
IC601(2)
→
L601
→
JT601(Charger)
→
JT101(Handset)
→
L101
→
Q101
→
D102
→
BAT-
TERY+... Battery... BATTERY-
→
R115
→
GND
→
L102
→
JT102(Handset)
→
JT602(Charger)
→
R616, R617, R618, R619
→
GND
→
DC-(GND)
In this way, the BBIC on Handset detects the fact that the battery is charged.
The charge current is controlled by switching Q101 of Handset.
4.2.4. Battery Low/Power Down Detector
Circuit Operation:
"Battery Low" and "Power Down" are detected by BBIC which check the voltage from battery.
The detected voltage is as follows;
• Battery Low
Battery voltage: V(Batt) 3.5V ± 50mV
The BBIC detects this level and " " starts flashing.
• Power Down
Battery voltage: V(Batt) 3.3V ± 50mV
The BBIC detects this level and power down.
4.2.5. Speakerphone and Headset Jack
The hands-free loudspeaker at CN401(1) and CN401(2) is used to generate the ring alarm. IC401 is used to switch off the tele-
phone loudspeaker and is used to amplify the signal to drive the hands-free loudspeaker. They are selected using the SP_AMP
line from pin 70 of the BBIC. 2.5mm headset jack is also available.