Important Information
SAVE THESE INSTRUCTIONS
Safety Notices
Please observe the safety notices in this manual in order to avoid danger to users or other people, and prevent
damage to property.
The notices are classified as follows, according to the severity of injury or damage:
WARNING
This notice means that misuse could result in death or serious injury.
CAUTION
This notice means that misuse could result in injury or damage to
property.
WARNING
SAFETY REQUIREMENTS
•
The product must only be installed and serviced by qualified service personnel. The product should be
used as-is from the time of purchase; it should not be disassembled or modified. Disassembly or
modification can cause a fire, electric shock, or damage to the product.
•
Make sure that the wall that the unit will be attached to is strong enough to support the unit (approx.
310 g [11 oz]). If not, it is necessary for the wall to be reinforced.
•
Only use the wall-mounting equipment (screws, washers, wall mounting plate) included with the unit.
•
When this product is no longer in use, make sure to detach it from the wall.
•
Do not connect or disconnect the telephone cord with wet hands.
•
Disconnect the unit from the telephone cord, and contact the dealer if:
–
The unit is exposed to rain, water, or any other liquid.
–
The unit is dropped or damaged.
–
Internal components are exposed due to damage.
–
The unit does not operate properly.
–
Performance deteriorates.
•
Disconnect the unit from the telephone cord if the unit emits smoke, an abnormal smell, or makes
unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has stopped and
contact an authorized service center.
•
Do not touch the unit, or telephone cord during a lightning storm.
•
Do not allow anything to rest on the telephone cord. Do not locate this unit where the telephone cord
may be stepped on or tripped on.
CAUTION
SAFETY REQUIREMENTS
•
The CS should be kept free of dust, moisture, high temperature (more than 40 °C [104 °F]), low
temperature (less than 0 °C [32 °F]), and vibration, and should not be exposed to direct sunlight.
•
The CS should not be placed outdoors (use indoors).
•
The CS should not be placed near high-voltage equipment.
•
The CS should not be placed on a metal object.
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
•
To prevent malfunction, deformity, overheating, rust, and discoloration, do not install or place
equipment in the following types of locations:
2
Quick Installation Guide
Document Version 2009-12
Important Information
