Menu list
Problem
Cause/solution
The display is in a
language I cannot read.
R
Change the display language (page 12).
I cannot activate the eco
mode.
R
You cannot set eco mode when you set the DECT repeater
mode
“
On
”
. If required, set the DECT repeater mode to
“
Off
”
(page 34).
I cannot display the
wallpaper.
R
Wallpaper is displayed in the standby mode only when you
select
“
Digital(Small)
”
or
“
Off
”
for the clock setting.
Change the clock setting (page 24).
I cannot register a handset
to a base unit.
R
The maximum number of base units (4) is already registered to
the handset. Cancel unused base unit registrations from the
handset (page 33).
R
The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 33).
R
You entered the wrong PIN. If you forget your PIN, contact an
authorised service centre.
Battery recharge
Problem
Cause/solution
The handset beeps and/or
flashes.
R
Battery charge is low. Fully charge the batteries (page 9).
I fully charged the
batteries, but
–
still flashes or
– the operating time
seems to be shorter.
R
Clean the battery ends (
,
) and the charge contacts with
a dry cloth and charge again.
R
It is time to replace the batteries (page 9).
Making/answering calls, intercom
Problem
Cause/solution
is displayed.
R
The handset is too far from the base unit. Move closer.
R
The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R
The handset is not registered to the base unit. Register it
(page 33).
R
Activating one touch eco mode reduces the range of the base
unit in standby mode. If required, turn eco mode off (page 13).
48
Useful Information
PRS120AZ(en)_0724_ver012.pdf 48
PRS120AZ(en)_0724_ver012.pdf 48
2013/07/24 11:29:11
2013/07/24 11:29:11