Conditions
Note
[Caller ID Modification]
If "–" is included in the received Call ID, it is ignored by the Call ID
modification.
[Caller ID Modification by Length of Digits]
•
The length of digits for National must be set smaller than
International.
•
It is possible to specify whether to modify the caller ID received
from an Analog trunk or SIP trunk.
[Caller ID Modification by Leading numbers]
The Modification table has 10 entries. It is possible to make an
exception setting in case the caller's number does not match any of
the 10 set entries.
[DDI/DIL distribution]
When the modified number is not registered in System Speed
Dialing table, or the setting of the incoming call destination for each
modified number does not exist, the call will be handled using the
DDI/DIL distribution methods specified for each trunk. The call is
disconnected when DDI/DIL settings are not programmed.
Refer to 3.1.2 Direct Inward
Dialing (DID)/Direct Dialing In
(DDI)
PIL Reference
2.4.4 PBX Configuration—[3-4] Trunk—Caller ID Modify & Block
2.6 PBX Configuration—[5] System Speed Dialing
3.1.2 Direct Inward Dialing (DID)/Direct Dialing In (DDI)
Description
Provides automatic direction of an incoming call with a DID/DDI number to a preprogrammed destination.
Each DID/DDI number has a destination for each time mode (day/lunch/night).
Incoming calls with DID/DDI numbers that match extension numbers at this PBX will be sent to the
corresponding extension.
For other incoming trunk call distribution methods, the priority of methods is as follows:
1.
CLI Destination
2.
DID/DDI
3.
DIL
Important
FWD No Answer Time
is used as the timer for forced call disconnection. For more information, refer to
Conditions
Note
DID/DDI can be enabled or disabled for each SIP carrier in the
system.
When DID/DDI is disabled, DIL
will operate. Refer to 3.1.3 Direct
In Line (DIL)
3.1.2 Direct Inward Dialing (DID)/Direct Dialing In (DDI)
Feature Manual
23
Содержание KX-HTS824
