Replacing the battery
Use this procedure when replacing the
battery after installation.
1
Remove the sensor from the
mounting adaptor by pressing the
release lever, sliding the sensor up
and lifting it away from the
mounting adaptor.
2
Remove the front cover.
3
Replace the battery with a new
one.
4
Attach the front cover.
5
Attach the sensor to the mounting
adaptor.
R
The sensor will click into place
when it is secured.
R
Make sure the “
UP
” marks on
the back of the sensor and the
inside of the mounting adaptor
point in the same direction.
Registering the
sensor
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the sensor, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the
[Home
Network]
app.
Using registration buttons
1
Hub:
Press and hold
M
OTHER
DEVICE
N
until the LED indicator
blinks slowly in green.
2
Sensor:
Remove the front cover, and then
press and hold
M
N
until the
LED indicator blinks slowly in
green (page 8).
R
When registration is complete,
the hub sounds one long beep.
Note:
R
To cancel without registering the
sensor, press
M
N
on the hub and
on the sensor again.
R
If registration fails, the hub sounds
several short beeps.
Using the app
When you register the sensor by using
the
[Home Network]
app, you can
assign it a name and location. For
more information, refer to the User’s
Guide (page 16).
10
For assistance, please visit http://shop.panasonic.com/support
Setup
HNS107_(en_en)_0120_ver.101.pdf 10
2017/01/20 21:11:39
