Panasonic KX-HNB700, Руководство пользователя, Страница: 30 / 96

Setting
[Silent Mode] [Protection Mode]
1st camera
2nd or later
camera
1st camera
2nd or later
camera
Recording On On On On
[Recording Duration] [10 sec] [10 sec] [10 sec] [10 sec]
[Sync] *1 Off Off Off Off
Push Notification On On On On
Camera Sound
[OFF] [OFF]
[Announcement
]
[OFF]
*1 Refer to “Sync”, Page 30 for more information.
Creating new modes
You can create new modes to operate access points and their connected cameras when an event occurs
such as motion is detected.
1
Access the mode screen ( “Accessing the mode screen”, Page 29).
2
Tap .
3
Change the settings as required.
R Each setting is explained in this section.
4
When finished, tap [OK] .
Mode Name
When creating a new mode, you can set the name used for the mode. This helps you to identify the
mode from other modes used on your mobile device.
–
To enter a name: Tap the text field, enter the text, and then tap [OK] .
Recording
You can enable and disable recording, and also specify the recording duration for each camera.
–
To enable/disable recording: Slide the switch next to each camera name to the desired position.
– To select a recording duration: Tap the time displayed next to each camera name, specify the
desired duration, and then tap [OK] .
Sync
You can coordinate cameras so that when 1 camera detects motion the other camera starts
pre-recording. (Images are temporarily stored, and if motion is detected later, images are then saved on
the access point’s SD card.)
–
To enable/disable camera coordination: Slide the [Sync] switch to the desired position.
Note:
R Sync is only available when 2 or more cameras are registered to the access point.
Push Notification
Push notifications are displayed on your mobile device when motion is detected.
–
To enable/disable push notifications: Slide the switch next to each camera name to the desired
position.
30
Using the app