Operating Instructions
5
Network Parameters
Preparing the Network Parameters for the Network Camera
Before starting to set up the network parameters of a Network Camera, make note
of corresponding network parameters.
Refer to page 6 in this Getting Started and page 23 in the Operating Instructions
for network parameters.
Network parameters memo for Network Camera
The devices on the network may not be assigned the same IP address. Each
device must have its own IP address. Overlapped IP addresses can cause other
network devices to stop working and may result in widespread network problems.
[Type 1]
Ask your network administrator for the network parameters.
[Type 2]
Refer to the broadband router’s manual for the network parameters.
[Type 3]
Ask your ISP (Internet Service Provider) for the network parameters.
[Type 4]
Install the Network Camera in the default condition. Set the PC
"192.168.0.250" (IP address) and "255.255.255.0" (Subnet Mask).
Refer to page 24 in the Operating Instructions.
Default Gateway . . .
DNS Server 1 . . .
IP Address . . .
DNS Server 2 . . .
Subnet Mask . . .
