![Panasonic KX-FP215 Скачать руководство пользователя страница 45](http://html.mh-extra.com/html/panasonic/kx-fp215/kx-fp215_operating-instructions-manual_267281045.webp)
9. Help
45
For assistance, please visit http://www.panasonic.com/help
9.3.2 General
Problem
Cause & Solution
The unit displays “
PAPER
JAMMED
” even though paper
is installed.
L
You forced the recording paper into the paper tray too strongly. Remove all
of the installed paper, and re-install it gently.
The unit displays “
CHECK
PAPER
” even though paper is
inserted.
L
The paper is inserted halfway. Insert it correctly (page 50) and press
{
SET
}
to clear the message.
The other party complains
they only hear a fax tone and
cannot talk.
L
FAX ONLY mode is set. Tell the other party the number is only used for
faxes.
L
Change the receiving mode to TAM/FAX mode (page 28) or TEL mode
(page 27).
L
If you use a Distinctive Ring service, make sure you have set the same ring
pattern assigned by the telephone company (page 30).
{
REDIAL
}
or
{
PAUSE
}
does
not function properly.
L
If this button is pressed during dialing, a pause will be inserted. If pressed
immediately after a dial tone is obtained, the last number dialed will be
redialed.
The receiving mode does not
function properly.
L
Distinctive Ring is set (feature #31 on page 30).
During programming, I
cannot enter the code or ID
number.
L
All or part of the numbers are the same as another code or ID. Change the
number:
–
remote operation ID: feature #11 on page 37.
–
fax activation code: feature #41 on page 40.
The ink film runs out quickly.
L
Even if there are only a few sentences, every page that comes out of the
machine is considered a full page.
L
Turn OFF the following features:
–
confirmation report: feature #04 on page 37.
–
journal report: feature #22 on page 38.
–
Caller ID list: feature #26 on page 38.
The unit beeps.
L
The memory reception alert of feature #44 is ON (page 40), and the unit has
a document in memory. Press
{
STOP
}
to stop the beeps, then see the
displayed message instructions to solve the problem.
Whenever I try to retrieve my
voice mail messages, I am
interrupted by the fax tone.
L
You are probably entering
{*}{#}{
9
}
. This is the default setting for the fax
activation code. If you use a voice mail service, turn the fax activation
feature OFF or reprogram the activation code (feature #41 on page 40).
The speakerphone is not
working.
L
Use the speakerphone in a quiet room.
L
If you have difficulty hearing the other party, adjust the volume.
The unit does not display the
caller’s name and/or
telephone number.
L
You need to subscribe to a Caller ID service.
L
Other telephone equipment may be interfering with your phone. Disconnect
it and try again.
L
Other electrical appliances connected to the same outlet may be interfering
with the Caller ID information.
L
Telephone line noise may be affecting the Caller ID information.
L
The caller requested not to send his/her information (page 20).
The display exits the Caller ID
list while viewing caller
information.
L
Do not pause for over 3 minutes while viewing.
FP215-PNQX1896ZA-OI-en.book Page 45 Tuesday, December 23, 2008 11:09 AM