8. Help
47
8.3.2 General
The unit does not ring.
L
The ringer volume is turned OFF. Adjust it (page 16).
Problem
Cause & Solution
The unit displays “
PAPER
JAMMED
” even though paper
is installed.
L
You forced the recording paper into the paper tray too strongly. Remove all
of the installed paper, and re-install it gently.
The unit displays “
CHECK
PAPER
” even though paper is
inserted.
L
The paper is inserted halfway. Insert it correctly (page 53) and press
{
SET
}
to clear the message.
The other party complains
they only hear a fax tone and
cannot talk.
L
FAX ONLY mode is set. Tell the other party the number is only used for
faxes.
L
Change the receiving mode:
–
KX-FP205: TEL mode (page 26) or TEL/FAX mode (page 27)
–
KX-FP215: TAM/FAX mode (page 28), TEL mode (page 26) or TEL/FAX
mode (page 27)
{
REDIAL
}
or
{
PAUSE
}
does
not function properly.
L
If this button is pressed during dialling, a pause will be inserted. If pressed
immediately after a dial tone is obtained, the last number dialled will be
redialled.
The ink film runs out quickly.
L
Even if there are only a few sentences, every page that comes out of the
machine is considered a full page.
L
Turn OFF the following features:
–
sending report: feature #04 on page 37.
–
journal report: feature #22 on page 39.
–
Caller ID list: feature #26 on page 39.
During programming, I
cannot enter the code or ID
number.
L
All or part of the numbers are the same as another code or ID. Change the
number:
–
remote operation ID: feature #11 on page 38.
–
fax activation code: feature #41 on page 40.
–
auto disconnection: feature #49 on page 41.
The unit beeps.
L
The memory reception alert of feature #44 is ON (page 41), and the unit has
a document in memory. Press
{
STOP
}
to stop the beeps, then see the
displayed message instructions to solve the problem.
The speakerphone is not
working.
L
Use the speakerphone in a quiet room.
L
If you have difficulty hearing the other party, adjust the volume.
The unit does not display the
caller’s name and/or
telephone number.
L
You need to subscribe to a Caller ID service.
L
Other telephone equipment may be interfering with your phone. Disconnect
it and try again.
L
Other electrical appliances connected to the same outlet may be interfering
with the Caller ID information.
L
Telephone line noise may be affecting the Caller ID information.
L
The caller requested not to send his/her information (page 20).
The display exits the Caller ID
list while viewing caller
information.
L
Do not pause for over 3 minutes while viewing.
Problem
Cause & Solution
FP205-215E-PFQX2485ZA-en.book Page 47 Wednesday, April 26, 2006 6:34 PM
Содержание KX-FP205
Страница 8: ...Table of Contents 8 11 Index 11 1 Index 59 ...
Страница 61: ...61 Notes ...
Страница 62: ...62 Notes ...
Страница 63: ...63 Notes ...