5 Operation Panel
1
2
3
5
4
6
7
LED (Red)
Lights when an error occurs.
LED (Green)
Shows the scanner’s status.
Power button ( )
For details, see "6.1.1 Turining ON/OFF the unit's power" (page 19).
Cursor button
Skip button (
)
If you press this button after a double feed is detected and scanning has been paused, the document (or
documents) detected as a double feed will be scanned, and then ejected from the scanner. Scanning will
continue after the document is scanned and ejected.
Start/Stop button (
)
•
If you set [Wait Key] for "Manual Feed Mode" in your application software, pushing this button starts
scanning. For details about "Manual Feed Mode", refer to the Image Capture Plus, TWAIN, or ISIS
help.
•
During scanning, pushing this button stops scanning.
•
If you press this button after a double feed is detected and scanning has been paused, the document
(or documents) detected as a double feed will be ejected from the scanner without being scanned.
Scanning will stop.
7-segment LED
If you are using the scanner with Image Capture Plus, you can perform a push scan using the 7-
segment LED. A registered job number is displayed on the 7-segment LED. Use the cursor button ( )
to select a job.
5 Operation Panel
17
