4.3 Installing the Software
Notice
•
Make sure to log on as an administrator to install the software.
•
Make sure to connect the unit to your computer after installing the software. Connecting the unit to
your computer and turning on the unit’s power before installing the software may influence the
software installation. If you connect the unit to your computer and turn on the unit’s power before
installing the software by mistake, install the software after disconnecting the unit from your computer.
The software on the enclosed Software / Manual CD-ROM can be installed on your computer.
You can select from the 2 installation methods below, depending on your needs.
a. Complete:
Install all the drivers, applications, utilities and Operating Manual.
b. Custom:
Install only selected items.
Note
•
Normally, it is recommended to select [Complete].
1.
Check that the unit has been turned OFF.
•
If the power is turned on, turn off the unit's power (page 19).
2.
Insert the Software / Manual CD-ROM into the CD/DVD drive on your computer.
Note
•
If the AutoPlay dialog box is displayed, select [CDRun.exe].
•
If the setup window does not appear, double-click [CDRun.exe] in the Software / Manual CD-
ROM.
•
When the model selection screen is displayed, select the correct model to use.
3.
Check the [Read me first] file.
4.
Select the desired installation methods from "Software" on the left side of the screen.
•
If you selected [Custom], select the items that you want to install. If you select TWAIN or ISIS, Image
Capture Plus will also be installed.
5.
Follow the instructions on the screen and complete the installation.
•
Restart your computer if you are prompted to do so.
6.
Plug in the power cord and connect the USB cable.
7.
Turn ON the unit's power (page 19).
4.3 Installing the Software
15
