Put the Power Measuring Unit into registration mode.
18
1. Once the Gateway is in registration mode, the Application
LED on the front of the Gateway will flash in green.
2. Hold the SET button on the Power Measuring Unit for at least
3 seconds to put it into registration mode.
3. Once the REGISTER LED on the Power Measuring Unit changes
from flashing to permanently on, registration is complete
(the LED will turn off after 5 minutes).
After completing the above process, tap the
“Check” button to confirm registration.
Application
LED
17
Put the Gateway into
registration mode.
Check that the
Application LED is
flashing in orange.
Tap the “Activate
Registration Mode”
at the bottom of
the screen to enter
the Gatewayʼs
device registration
mode.
Tap the
“Next” button
to move to
the next step.
The smartphone is
successfully connected
to the Gateway.
16
Setup the Power Measuring Unit
Installer Tasks
Go to the next step
Tap "Next" button to proceed to the next step.
*If not connedted to the Gateway properly,
an error screen will be displayed after tapping "Next" button.
STEP2
21