128
VQT2M51
Problem
Check points
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥
Remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC
adaptor. Then about 1 minute later, turn on the power
again. (Conducting the above operation while the
media is being accessed may damage the data on
the media.)
≥
If normal operation is still not restored, detach the
power connected, and contact consumer support.
(
l
152, 153)
Item other than the
touched one is
selected.
≥
Calibrate the touch screen. (
l
49)
The remaining time
indication or the
elapsed time
indication is not
shown.
≥
[DISPLAY] of the [SETUP] is [OFF]. (
l
44)
The unit arbitrarily
stops recording.
≥
Use an SD card that can be used for motion picture
recording. (
l
26)
≥
The recordable time may have shortened due to the
deterioration of the data writing speed or repeated
recording and deletion. Using the unit, format the SD
card, built-in memory or HDD. (
l
48)
≥
If [AGS] is [ON], record in the normal horizontal
position or set [AGS] to [OFF]. (
l
66)
≥
If the unit is exposed to strong vibrations or shocks
while recording on HDD, recording may stop to
protect the HDD. If the unit is used in a place with
loud sounds, the recording may stop due to sound
vibrations. Recording data on an SD card is
recommended in these places.
Auto focus function
does not work.
≥
Switch to Intelligent Auto Mode.
≥
If you are trying to record a scene which is hard to
bring into focus in Auto Focus Mode, use the Manual
Focus Mode to adjust the focus. (
l
39, 77)
HDCSD60_TM60_HS60-P_PC-VQT2M51_eng.book 128 ページ ２０１０年１月１８日 月曜日 午前１１時３３分
